Hi can anyone point me in the right direction. The websites have changed while I have been off the radar. I need the some assistance and cant find anything. I am laying out my chainplate gussets and remember seeing some posts where this was explained incl pictures (for us dummies). I am under the impression that I need to set my gussets back at an angle of 22deg from the centre of the mast base (I am going to use a C-Tech mast). Can someone confirm my intended angle and tell me where the post may be hiding. A heads up on where everything has gone would be wonderful as well.
Thanks
Clockwork Mouse #203 AUS
layout of chainplate gussets
2 posts
• Page 1 of 1
layout of chainplate gussets
by jmac » Thu Jul 19, 2012 3:35 am
- jmac
- Posts: 2
- Joined: Tue Mar 20, 2012 2:43 pm
Re: layout of chainplate gussets
by jray » Thu Jul 19, 2012 11:51 am
Kevin did up a drawing years ago for the C-Tech masts sent here to the states. If they are using the same angles for the spreader everything should be good. Welcome Back!
You do not have the required permissions to view the files attached to this post.
Jon
#061 Critical Twist
#061 Critical Twist
- jray
- Posts: 531
- Joined: Fri Mar 25, 2011 6:26 pm
- Location: Polson, Montana
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests